If you don't have a soldering iron, just pick the resistors off. BE CAREFUL! I AM NOT RESPONSIBLE FOR ANY DAMAGE DONE TO YOUR eMAC, YOU ARE!
All you do is take the motherboard out, and remove the following resistors:
1.42GHz model (UNKNOWN, MAY NOT WORK):
People have tried getting up to higher speeds, but those don't really work unless you raise the voltage.
R453 = Vid0
R454 = Vid1
R455 = Vid2
R456 = Vid3
R457 = Vid4
There is more info by another guy, but he speaks in french: https://sites.google.com/site/overclockmac/g4emac2
-The french guy's site (Credit goes to him for the images)
I did something similar, went from an eMac 1GHz to 1.25GHz. Works flawlessly.
if you find info on these eve cards thank you.
Was it an ATI graphics model? I know those can go to 1.33GHz.I did something similar, went from an eMac 1GHz to 1.25GHz. Works flawlessly.
Refer to this: https://web.archive.org/web/20000418021 ... cpce1.htmlI am looking to boost a 9600 CPU card from 300 Mhz to 400 Mhz.